Design Methane Pressure or Soil Formation Pressure: As per the Los Angeles Department of Building and Safety (LADBS) Methane Code, Ordinance Number 175790, Design Methane Pressure means the highest observed measurement of soil formation pressure during the methane testing process. In fact, a Design Methane Pressure measurement that is above 2 inches of water results in stricter methane mitigation standards.
Petroleum Extraction Well (Oil Well) Petroleum Extraction Well (Oil Well): A petroleum extraction well, or an oil well, is a deep borehole or shaft sunk into the Earth for the exploration of oil or gas. Additionally, injection wells are often drilled to inject fluids or gas for stimulating oil recovery, re-pressurizing or pressure maintenance of…
Dip-Slip Fault Dip-Slip Fault: In geology, a dip-slip fault is any fault in which the earth’s movement is parallel with the dip of the fault plane. For example, a normal fault, reverse fault, or listric fault. The opposite of a dip-slip fault is a strike-slip fault.
Runoff (R) The term “Runoff” (R) in hydrogeology and geology refers to the part of rainfall which accumulates on the ground surface and naturally forms into flowing streams.
What is a Concrete Gravity Dam? A Concrete Gravity Dam is also known as “Gravity Arch Dam,” and is a freshwater-retaining concrete structure that has a wider footing (base) than the top-section. The purpose of a Concrete Gravity Dam is to maintain a low center of gravity, in order to avoid collapsing in the event…
Volcanology Volcanology: Volcanology is a branch of geology that focuses on the study of volcanos. In volcanology, geologists conduct field and laboratory investigations to learn about continental, coastal, and submarine volcanic activities. In fact, volcanology ties into many other branches of geology. For instance, a volcanologist may study the geochemistry of igneous rocks, such as…
Consolidation “Consolidation” in geology refers to the gradual or slow reduction in the volume of a soil sample (representing a larger soil mass), and the increase in density in response to an applied increasing load, or compressive stress.
